Basic functions of the ACS basic models
- - central parametric operator interface
- - processing of solid material is possible within the weight limits
- - simultaneous production of 3 different workpiece lengths is possible. Discharge of 2nd and 3rd work piece length can be directed to the rear of the machine or through the chip conveyor.
- - data management of all workpiece related parameters, approx. 10,000 different workpieces
- - storage of each individual workpiece processed, measured values etc., approx. 50,000,000 pieces
- - material lead edge detection (light sensor)
- - detection of the end of the material (light sensor), scrap end length sensor
- - automatic adjustment of workpiece length and temperature compensation with existing length measuring device
- - saw blade / saw drive monitoring
- - minimum torque
- - maximum torque
- - operating limits of saw torque (preset parameters via operator panel)
- - operating limits workpiece counter (preset parameters via operator panel)
- - operating limits cutting area (preset parameters via operator panel)
- - operating limits saw blade temperature (optional) (preset parameters via operator panel)
- - tool break monitoring
- - crash monitoring with logging
- - quick return of saw blade (10ms) in case of crash, emergency stop or power failure
- - vibration monitoring, operating limits vibration
- - calculation and display of critical cutting speed for applicable saw blade
- - rejection of 1st workpiece after incomplete saw cut, for example after emergency stop or crash
- - monitoring of clamping device of the grip feeder, including position measuring system
- - monitoring of minimum clamping force (preset parameters via operator panel)
- - monitoring of maximum clamping force (preset parameters via operator panel)
- - continuous clamping force adjustment (preset parameters via operator panel)
- - rejection of workpiece upon machine fault
- - monitoring of clamping device of the saw, including position measuring system
- - monitoring of minimum clamping force (preset parameters via operator panel)
- - monitoring of maximum clamping force (preset parameters via operator panel)
- - continuous clamping force adjustment (preset parameters via operator panel)
ACS102 Sawing with length measuring (single length measuring)
Single cut
with a tool clamping range of 10 mm
from Ø 10 mm to Ø 105 mm, profile material 10x10 - 74x74 mm, 100x40 mm
for workpiece lengths ≥ 50 mm
profile 74x74 - 80x80 mm, 100x60 mm possible,
for workpiece lengths ≥ 50 mm
cannot be rejected during length measuring,
machine will stop automatically in case of faulty length
Double cut only single length measuring
with a tool clamping range of 5 mm
from Ø 10 mm up Ø 45 mm
for workpiece lengths ≥ 50 mm
Triple cut only single length measuring
with a tool clamping range of 5 mm
from Ø 14 mm to Ø 31.5 mm
for workpiece lengths ≥ 50 mm
Quadruple cut only single length measuring
with a tool clamping range of 2 mm
from Ø 10 up Ø 14 mm
for workpiece lengths ≥ 50 mm
possible combinations for ACS102...+LM with length measuring
→ Container
→ +SCB → Container
→ +TI +SRT → Container
→ +Pi ACS reverse loader with belts / chains, for workpiece accumulation
LM length measuring on ACS102..., ACS102...+CFM...
- - Ø 10 mm to Ø 92 mm measuring at diameter (2 measuring points per end) by means of two parallel measuring jaws
- - Ø 92 mm to Ø 105 mm measuring lower wall at diameter (1 measuring point per end) by means of two parallel measuring jaws
- - gauge of measuring jaw 10 mm
- - measuring standard, Heidenhain - absolute
- - measuring capability, standard deviation Sg <= 0.001 mm
- - Calibration standard Ø 30x150 mm will be supplied